Page 1 of 1

Tiger output/sound issue

PostPosted:Wed Dec 19, 2018 12:03 pm
by gr8fl4295
Hey guys,
I'm having problem with my Tiger.
I'm getting very little or no output (sound) from the guitar. I've tried different cables, different amps, by-passing the effects. I've changed the 8 volt battery as well.
I also have a Les Paul and it plays fine plugged in to the same gear.

My setup is:

Tiger (w/OBEL) > dual cable > Junction Box > Effects Pedals > SMS Classic Tube PreAmp > McIntosh 50 Amp > JBL 10” speaker

Do you have any idea what it might be? Did something get fried?

Thanks for any suggestions.

Best,
Derek

Re: Tiger output/sound issue

PostPosted:Wed Dec 19, 2018 12:23 pm
by bzbz
you have plugged it in direct to amp using guitar cable only yes? (no OBEL or junction box)

Re: Tiger output/sound issue

PostPosted:Wed Dec 19, 2018 1:01 pm
by gr8fl4295
Yes.
Straight into the gear I mentioned as well as a separate amp.

Re: Tiger output/sound issue

PostPosted:Wed Dec 19, 2018 10:33 pm
by TI4-1009
Upgrade to a 9 volt battery.

Ba Da Bump..shhhhhhh.

Re: Tiger output/sound issue

PostPosted:Fri Dec 21, 2018 11:36 pm
by GeneralGoldilocks
could be a grounding issue in the guitar, usually at the jack.

Re: Tiger output/sound issue

PostPosted:Sat Dec 22, 2018 8:16 am
by ccw3432
Try plugging a standard guitar cable from the OBEL jack straight to the amp. Most OBELs are wired with the tip as the output and the ring as the return. When you turn the OBEL switch on do you get sound? If so, I would suspect a loose solder joint at the OBEL jack, the output jack, or the volume pot. If you don't get sound with this test check all your grounds and solder joints.