As folks think power, y'all as need to understand your voltages and mA draws and connectors. It takes a bit of work.
As an example I have some high draw pedals. Were fine til I added just 2 more pedal, then shit stopped working and got noisy.
I'm running CIOKS power now and HIGHLY satisfied with their ability to run a high draw board without falter or fail.
Link to board:
https://photos.app.goo.gl/TZru1ZMYGT2fLojz8
that MXR revierb is a power HOG so's the Glass-A. Nice setup to just plop down, run an XLR to FOH, take a monitor feed for IEM, run a snake cable up to my guitar and IEM, and ready to rock in minutes...
lbpesq wrote: ↑Thu Feb 10, 2022 7:53 pm
Another thing to consider. Since my new Quilter Aviator Mach 3 allows me to turn the effects loop on/off with a foot-switch, I’ve been experimenting with moving some of my pedals into the effects loop.
Bill, tgo
Do they should better there? I've done the whole 4CM pre effects, post effects, etc, etc... At the end I never found anything better in the effects loop only different. And yes, different could be preferred. But for me it was a lot of cabling and hassle for no reward. YMMV.